详细信息

CAT分散刀头由不锈钢制成，可耐受高温高压消毒。均采用相同的连接头，可与所有驱动电机连接，并易于拆卸与清洗。
主机
(1) X120 hand-held, high speeddrive motor for small volumes, electronically stabilised speed control for tools up to 17 mm, speed: 11.000 - 33.000 rpm, 140 W, 115 or 240 Volt, for shafts T6, T10 and T17.
(2) X360 drive motor , 360 Watt, fixed speed: 45.000 rpm, (for speed control please order speed control unit part no. 60493), 240 Volt, for shafts up to 20 mm (short-time duty).
P1500 Speed control unit for X 360
(3) X520 drive unit, 500 Watt, speed: 11.000 - 29.000 rpm, for dispersing tools up to 30 mm (short- time duty only!!!) 115 or 240 Volt.
(4) X520D same as X 520 but with LCD-display for speed
(5) X620 drive unit, 600 Watt, built-in speed control, 8.000 - 24.000 rpm. Only in 240 Volt available.
(6) X1030 powerful and robust drive motor, 1 kW, with electronic speed control, for tools up to 30 mm Speed range: 10.000 - 24.000 rpm
(7) X1030D as X1030 but with LCD display
(8) X1740 Very powerful drive motor, steplessly adjustable, without display, suitable for all shafts up to T/G 40, 5.000 - 22.000 rpm, 1500 Watt.
(9) XP28 Compressed-air motor, air consumption 0,6m/min at 6 bar pressure, max. 28.000 rpm
(10) XP44 Compressed-air motor, air consumption 0,35m/min at 6 bar pressure, max. 44.000 rpm

数显型主机

（1）X520Dsame as X 520 but with LCD-display for speed
（2）X1030D sameas X1030 but with LCD display

分散刀具

T6 Shaft, 6 mm diameter, 55 mm long, complete with generator
T6 Shaft, 6 mm diameter, 120 mm long, complete with generator
T10 Shaft, 10 mm diameter complete with generator
T17 Shaft, 10 mm diameter, complete with 17 mm generator
T20 Shaft, 20 mm diameter, complete with generator
G20 Shaft, 20 mm diameter, complete with generator
T30 Shaft, 20 mm diameter, complete with 30 mm generator
G30 Shaft, 20 mm diameter, complete with 30 mm generator
T40 Shaft, 20 mm diameter, complete with 40 mm generator
G40 Shaft, 20 mm diameter, complete with 40 mm generator
additional charge for knife generator
"*Please add one of the capitol letters to the order no. When ordering shafts:
- V = for medium viscosities
- N = for low viscosities
- F = for fine dispersion tasks
- M = knife generator (e.g. cut down of drugs, tissues)"

连续流研磨

（1）DK30 Flow Through Chamber for shafts G20 and G30
（2）DK40 Inline-disperser consisting of drive unit X 1740, flow-through chamber with external coo领, bench mounting device and G 40 generator. Also available without drive unit, if there already is an X1740 drive unit

说明：更多产品信息请与我们联系或登录 www.cat-ing.de

技术资料

2分散刀头产品样册