NCAT燃烧法沥青含量试验机-北京科百宏业科技有限公司

详细信息

燃烧法沥青含量测试仪

性能可靠稳定的沥青含量测定燃烧炉
热科学仪器NCAT沥青含量燃烧炉能够容纳大量的测试样品，降低劳动成本。
沥青含量燃烧炉通过环境友好、具有成本效益的燃烧法测定沥青含量，节约了时间和成本。
燃烧法替代昂贵和费时的溶剂萃取法，去除了溶剂的成本，在最少26-32周的溶剂成本的节省就能支付燃烧炉的费用。
本设备是与美国国家沥青技术中心（NCAT）共同开发，制定了燃烧法测定沥青含量的行业标准。本系统是起草和制定ASTM D6307 和 AASHTO T308标准的基础，NCAT专门用本设备进行了12个实验室所提出的现场试验，测试结果和性能证明在NCAT有备案证明。

性能特点
★沥青混合料的沥青含量的精确到0.11%；
★样品能容纳5000g；
★自动模式：端点检测、软件结束测试，按下停止后打开门锁，打印结果并发声提示（按照AMRL规格）；
★手动模式：端点检测，燃烧炉发声但继续测试直到停止打开门，然后打印结果；
燃烧炉自动补偿由于试样组件温度变化而发生的量变；
★全天或一周编程定时器对燃烧炉预热；
★RS-232端口提供的数据接口能与计算机进行图形数据分析

The most reliable asphalt content ignition furnace with a proven track record.

Thermo Scientific* NCAT asphalt content furnace accommodates larger sample testing, reducing labor and costs.

The Thermo Scientific NCAT Asphalt Content Furnace saves time and money by using an environmentally friendly, cost-effective ignition method to determine asphalt content. Ignition method replaces the costly and time consuming solvent extraction method by eliminating the cost of solvent and can pay for the cost of the furnace in as little as 26-32 weeks based on solvent cost savings alone

The Thermo Scientific NCAT Asphalt Content Furnace, developed in conjunction with the National Center for Asphalt Technology (NCAT), set the industry standard for determining asphalt content by the ignition method. This system was integral to the drafting and passage of ASTM* D6307 and AASHTO T308. A 12-lab roundrobin field test was conducted by NCAT exclusively with this furnace. Results and proven performance are documented by NCAT.

Operating Features

Asphalt content of bituminous paving mixtures is accurate to 0.11%
Accommodates samples up to 5000g
Automatic mode: endpoint is detected and software ends the test, prints the results and beeps until STOP is pressed to unlock door (in accordance with AMRL specifications)
Manual mode: endpoint is detected and furnace begins to beep but continues to test until STOP is pressed to unlock door, then and results print
Furnace software automatically compensates for weight change due to sample and basket assembly temperature change
24-hour/7-day timer can be programmed to preheat furnace
RS-232 port provides data interface with a PC for graphical data analysis